Preliminary Procedures

1. Heat the rear window name decal using a J-25070 gun or equivalent, 152 mm (6 in) from the glass surface.
2. Apply the heat using a circular motion, for about 30 seconds.

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

3. Remove the decal from the surface using a plastic, flat-bladed tool.
4. Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent.
5. Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent.

Special Tools

J-25070 Heat Gun 500-750°F

1

Rear Window Name Decal

Tip
The rear window name decal is serviced as one part.