J 36660-A /SA9140E Torque Angle Meter
Notice: Refer to Fastener Notice in the Preface section.
6.1. | Tighten the crankshaft bearing bolts in sequence. |
Tighten
Tighten the crankshaft bearing bolts to 20 N·m (15 lb ft).
6.2. | Tighten the crankshaft bearing bolts in sequence. |
Tighten
Tighten the crankshaft bearing bolts 70 degrees using the torque
angle meter.
Tighten
Tighten the lower crankcase perimeter bolts to 25 N·m
(18 lb ft).
J 45059 Angle Meter
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
6.1. | Tighten the crankshaft bearing bolts in sequence. |
Tighten
Tighten the crankshaft bearing bolts to 20 N·m (15 lb ft).
6.2. | Tighten the crankshaft bearing bolts in sequence using the J 45059 . |
Tighten
Tighten the crankshaft bearing bolts 70 degrees using the angle meter.
Tighten
Tighten the lower crankcase perimeter bolts to 25 N·m (18 lb ft).