Tools Required

J 44809 Output Shaft Seal Installer

1. Carefully pry out the output shaft seal and discard.
2. Remove the old seal material from the seal bore area by cleaning the area.



3. Using the J 44809 , install the NEW output shaft seal.
4. Check the fluid level. Fluid level should be to the bottom of the fill plug hole threads.
5. Clean the drain plug.

Notice: Refer to Fastener Notice in the Preface section.

6. Install the fill plug. Apply sealant Saturn P/N 21005994 to the threads.

Tighten
Tighten the fill plug to 15 N·m (11 lb ft).