Tools Required

J 44337 Build Plate Assembly

1. Remove the 2 remaining bolts and the drive pulley cover from the case cover assembly.
2. Remove the 2 drive pulley cover seals. Discard the seals.



3. Remove the 2 remaining bolts and the driven pulley cover from the case cover assembly.
4. Remove the 2 driven pulley cover seals and the case cover O-Ring seal. Discard the seals.




Important: Ensure the belt assembly is properly secured with two tie straps. If the belt assembly is not properly secured, the belt elements and ringset may separate.

5. Install a tie strap on each side of the belt assembly.



6. Remove the 3 nuts and the drive pulley bearing retainer.



7. Remove the 6 bolts and the driven pulley bearing retainer.



8. Remove the retaining ring for the drive pulley bearing.




Important: When positioning the U-shaped ring of the J 44337 , ensure that the lip of the U-shaped ring is resting on the top edge of the driven pulley crimp.

9. Position the U-shaped ring of the J 44337 on the driven pulley assembly.
10. Position the clamp U-bolts of the J 44337 in the slotted grooves of the U-shaped ring.



11. Using both hands, push down on the clamp handles with equal pressure in order to compress the driven pulley assembly.



12. Depress the follower and remove the case cover assembly.