Tools Required

Notice: Bearings and cups must be replaced as a set. Do not replace a bearing without also replacing the corresponding cup, or replace a cup without replacing the corresponding bearing. Failure to replace both components may damage the front differential carrier assembly.

1. Using the J 22912-B and an arbor press, remove the bearing assembly from the front differential drive pinion gear - transmission case side.



2. Using the J 22912-B and an arbor press, remove the bearing assembly from the front differential drive pinion gear - torque converter and differential housing side.



3. Using the J 43075 and an arbor press, install the bearing assembly on the front differential drive pinion gear - transmission case side.



4. Using the J 43075 and an arbor press, install the bearing assembly on the front differential drive pinion gear - torque converter and differential housing side.



5. Install the J 45115 into the drive pinion gear bearing cup on the transmission case assembly.
6. Using 2 wrenches, tighten the J 45115 .



7. Using a wrench, the J 45124 and the J 45115 , remove the drive pinion gear bearing cup from the transmission case assembly.

Important: The bearing shim is reusable.

8. Remove the drive pinion gear bearing shim from the transmission case assembly.



9. Install the J 45115 into the drive pinion gear bearing cup on the torque converter and differential housing assembly.
10. Using 2 wrenches, tighten the J 45115 .



11. Using a wrench, the J 45124 and the J 45115 , remove the drive pinion gear bearing cup from the torque converter and differential housing assembly.

Important: The bearing shim is reusable.

12. Remove the drive pinion gear bearing shim from the torque converter and differential housing assembly.



13. Install the drive pinion gear bearing shim into the transmission case assembly.



14. Using the J 8092  (1), the J 43075  (2) and a hammer, install the drive pinion gear bearing cup into the transmission case assembly.



15. Install the drive pinion gear bearing shim into the torque converter and differential housing assembly.



16. Using the J 8092  (1), the J 43075  (2) and a hammer, install the drive pinion gear bearing cup into the torque converter and differential housing assembly.