GM Service Manual Online
For 1990-2009 cars only

Terminal Removal Procedure

Follow the steps below in order to repair push to seat connectors.


    Object Number: 8802  Size: SH
  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves (1).

  3. Object Number: 8803  Size: SH
  4. Use the proper pick or removal tool (1) in order to release the terminal.
  5. Gently pull the cable and the terminal (2) out of the back of the connector.

  6. Object Number: 8804  Size: SH
  7. Re-form the locking device if you are going to reuse the terminal (1).
  8. To repair the terminal, refer to Terminal Repair.

Terminal Installation Procedure

  1. In order to reuse a terminal or lead assembly. Refer to Wiring Repairs .
  2. Ensure that the cable seal is kept on the terminal side of the splice.
  3. Insert the lead from the back until it catches.
  4. Install the TPA, CPA and/or the secondary locks.