GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

Connector End View Reference: Engine Electrical Connector End Views , Engine Control Module Connector End Views in Engine Controls - 2.2L (L61), or Powertrain Control Module Connector End Views in Engine Controls - 3.5L (L66)

1

Did you perform the Diagnostic System Check for Engine Electrical?

--

Go to Step 2

Go to Diagnostic System Check - Engine Electrical

2

  1. Start the engine.
  2. Turn Off all accessories.

Does the battery charge indicator remain illuminated?

--

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

3

  1. Install a scan tool
  2. With a scan tool, observe the Battery 1 parameter in the body control module (BCM) data list.

Does the voltage measure within the normal operating range?

12.6-16.0 V

Go to Step 4

Go to Charging System Test

4

With a scan tool, observe the Battery 1 parameter in the powertrain control module (PCM) data list.

Does the voltage measure within the normal operating range?

12.6-16.0 V

Go to Step 5

Go to Charging System Test

5

With a scan tool, command the lamp and gages On and Off.

Does the charge indicator turn On and Off with each command?

--

Go to Step 6

Go to Step 7

6

Important: The replacement ECM must be programmed.

Replace the ECM. Refer to Engine Control Module Replacement in Engine Controls - 2.2L (L61) or Powertrain Control Module Replacement in Engine Controls - 3.5L (L66)

Did you complete the replacement?

--

Go to Step 8

--

7

Replace the instrument panel cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gages and Console.

Did you complete the replacement?

--

Go to Step 8

--

8

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2