Relay Replacement Attachedto Wire Harness
Removal Procedure
- Locate the relay. Refer to the
Master Electrical Component List to locate the relay in the vehicle.
- Remove any fasteners which hold the relay in place.
- Remove any connector position assurance (CPA) devices or secondary locks.
Note: Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.
- Separate the relay (1) from the wire harness connector (2).
Installation Procedure
- Connect the relay (1) to the wire harness connector (2).
- Install any connector position assurance (CPA) devices or secondary locks.
- Install the relay using any fasteners or tape that originally held the relay in place.
Relay Replacement Within an Electrical Center
Removal Procedure
- Remove the electrical center cover.
- Locate the relay. Refer to
Electrical Center Identification Views
to locate the electrical
center where the relay exists.
Important:
• | Always note the orientation of the relay. |
• | Ensure that the electrical center is secure, as not to put added stress
on the wires or terminals. |
- Remove the relay from the electrical center.
Installation Procedure
- Install the relay in the same position as removed.
- Install the electrical center cover.