Circuit Description
The body control module (BCM) monitors the windshield washer pump control circuit. When a front windshield wash is requested for more than 2 minutes, the BCM will turn OFF the windshield washer pump if the front wiper is NOT requested by the wiper switch.
Battery voltage for the windshield washer pump is supplied through the FRT WIPER 25 A fuse and windshield wiper washer switch. Grounding for the windshield washer pump is through the OFF position of the rear washer switch, when equipped.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B3708 Front Washer Motor Input High
Conditions for Running the DTC
The ignition is in RUN or ACC position.
Conditions for Setting the DTC
The front windshield washer pump control circuit is shorted to battery voltage for 2 minutes.
Actions Taken When the DTC Sets
| • | No light will illuminate in the instrument panel (I/P). |
| • | Default turns OFF the washer motor after failing DTC if the wiper input is not active. |
Conditions for Clearing the DTC
| • | A current DTC clears when the fault is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the fault. |
Diagnostic Aids
| • | Check for a poor connection at the BCM. Inspect the harness connectors for backed out terminals, improper terminal mating, broken connector locks, improperly formed or damaged terminals, and poor terminal-to-wire connection, terminal crimped over wire insulation and not conductors. |
| • | Inspect the wiring harness for damage. Check for broken or chaffed insulation. |
| • | If a fault is suspected to be intermittent, wiggling the harness wiring may help in locating the fault. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Does the scan tool indicate the correct washer pump status, ON/OFF? | Go to Diagnostic Aids | Go to Step 3 |
3 |
Does the scan tool indicate the switch is OFF? | Go to Step 5 | Go to Step 4 |
4 |
Did you find and correct the condition? | Go to Step 7 | Go to Step 6 |
5 | Replace the windshield wiper washer switch. Refer to Turn Signal Multifunction Switch Replacement in Steering Wheel and Column. Did you complete the replacement? | Go to Step 7 | -- |
6 | Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | Go to Step 7 | -- |
7 |
Does the DTC reset? | Go to Step 2 | System OK |
