GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2005 🢒 VUE - FWD 🢒 Restraints 🢒 SIR 🢒 Seat Belt Indicator Circuit Malfunction

Step

Action

Yes

No

Schematic Reference: Seat Belt Schematics

1

Did you review the Seat Belt System Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Seat Belts

2
  1. Turn ON the ignition, with the engine OFF.
  2. Monitor the fasten safety belt indicator while buckling and unbuckling the driver seat belt.

Does the system operate properly?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

With a scan tool, observe the Driver Side Belt Status parameter in the SIR scan tool data list.

Does the scan tool indicate that the Driver Side Belt Status parameter displays Buckled?

Go to Step 4

Go to Step 7

4
  1. Turn OFF the ignition.
  2. Disconnect the inflatable restraint sensing and diagnostic module (SDM) connector. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
  3. Disconnect the seat belt switch - LF connector. Refer to Front Seat Belt Buckle Replacement .
  4. Test the seat belt switch - LF signal circuit for an open or a high resistance.

Did you find and correct the condition?

Go to Step 10

Go to Step 5

5

Test the seat belt switch - LF ground circuit for an open or high resistance.

Did you find and correct the condition?

Go to Step 10

Go to Step 6

6
  1. Test the seat belt switch - LF for an open.
  2. Replace the seat belt switch - LF if it is malfunctioning. Refer to Front Seat Belt Buckle Replacement .

Did you find and correct the condition?

Go to Step 10

Go to Step 9

7
  1. Turn OFF the ignition.
  2. Disconnect the SDM module connector. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
  3. Disconnect the seat belt switch - LF connector. Refer to Front Seat Belt Buckle Replacement .
  4. Test the seat belt switch - LF signal circuit for a short to voltage or a short to ground.

Did you find and correct the condition?

Go to Step 10

Go to Step 8

8
  1. Test the seat belt switch - LF for a short.
  2. Replace the seat belt switch - LF if it is malfunctioning. Refer to Front Seat Belt Buckle Replacement .

Did you find and correct the condition?

Go to Step 10

Go to Step 9

9

Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 10

--

10

Operate the system in order to verify the repair.

Did you find and correct the condition?

System OK

Go to Step 3