For 1990-2009 cars only
- Clean the brake shoe lining contact surface of the brake drum with denatured alcohol or an equivalent approved brake cleaner.
- Using a brake drum micrometer calibrated in thousandths of an inch, measure and record the largest diameter of the brake drum at 4 or more points, equally spaced around the drum.
- Compare the largest diameter measurement recorded to the following specifications:
- If the largest diameter measurement of the brake drum is less than the maximum allowable inside diameter after refinishing specification, the drum may be refinished, depending upon surface and wear conditions.
- If the largest diameter measurement of the brake drum is equal to the maximum allowable diameter after refinishing specification, the drum may not be refinished.
- If the largest diameter measurement of the brake drum is greater than the discard diameter specification, the drum requires replacement.
Caution: Refer to Brake Dust Caution in the Preface section.
Ensure the measurements are only taken within the brake shoe lining contact area. The micrometer must be positioned the same distance from the outside edge of the drum for each measurement.
Specification
| • | Brake drum maximum allowable diameter after refinish: 251.5 mm (9.90 in) |
| • | Brake drum discard diameter: 251.5 mm (9.90 in) |
