Removal Procedure
Important: There are 2 fuel level sender unit and float assemblies in the fuel tank. There is 1 located on each fuel pump module. The fuel level sender unit and float is NOT the same for each of the fuel pump modules.
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Remove the fuel pump module . Refer to
Primary Fuel Tank Module Replacement
.
- Disconnect the fuel level sender unit and float electrical connector from the underside of the top of the pump module.
- Release the retaining tabs (1, 2) and remove the level sensor by sliding up.
Installation Procedure
- Install the fuel level sender unit and float onto the fuel pump module. Make sure that the sender cap snaps into place (1, 2).
- Connect the fuel level sender unit and float electrical connector.
- Install the fuel pump module into the fuel tank. Refer to
Primary Fuel Tank Module Replacement
.
- Install the fuel tank. Refer to
Fuel Tank Replacement
.