Circuit Description
The fog lamp relay is controlled by the body control module (BCM). The BCM grounds the fog lamp relay control circuit in order to turn ON the fog lamp relay. When the fog lamp relay control circuit opens or becomes shorted to ground without being commanded ON by the BCM, DTC B2532 is set.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B2533 Front Fog Lamps Control Circuit High
Conditions for Running the DTC
| • | The ignition switch is in the ON position. |
| • | The headlamp switch is in the PARK or HEAD position. |
Conditions for Setting the DTC
All of the following conditions must be met:
| • | The ignition switch is in the ON position. |
| • | The headlamp switch is in the PARK or HEAD position. |
| • | The fog lamp relay control circuit is shorted to battery positive voltage for 250 milliseconds. |
Action Taken When the DTC Sets
| • | DTC B2533 will be stored in the BCM memory. |
| • | The fog lamps are inoperative. |
Conditions for Clearing the DTC
| • | The conditions for setting the DTC are no longer present. |
| • | A history DTC clears after 100 malfunction-free ignition cycles. |
| • | The BCM receives the clear code command from the scan tool. |
Diagnostic Aids
| • | The fog lamps will only illuminate under the following conditions: |
| - | The park lamps or low beam headlamps are ON. |
| - | The highbeam headlamps are OFF. |
| - | The fog lamp switch is ON. |
| • | If the DTC is a history DTC, the problem may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections . |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
Listen for an audible click when the fog lamp relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
-
This step tests for voltage at the coil side of the fog lamp relay.
-
This step verifies that the BCM is providing ground to the fog lamp relay.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Fog Lights Schematics | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
Does the fog lamp relay state change with each command? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | |
Does the test lamp illuminate? | Go to Step 4 | Go to Step 8 | |
Does the test lamp turn ON and OFF with each command? | Go to Step 6 | Go to Step 5 | |
5 | Test the control circuit of the fog lamp relay for a short to voltage. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 11 | Go to Step 7 |
6 | Inspect for poor connections at the fog lamp relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 11 | Go to Step 9 |
7 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 11 | Go to Step 10 |
8 | Repair the open in the coil side battery positive voltage circuit of the fog lamp relay. Refer to Wiring Repairs . Did you complete the repair? | Go to Step 11 | -- |
9 | Replace the fog lamp relay. Did you complete the replacement? | Go to Step 11 | -- |
10 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 11 | -- |
11 |
Does the DTC reset? | Go to Step 2 | System OK |
