Tools Required

J 44809 Output Shaft Seal Installer

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the right rear wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
3. Remove the right rear wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement .
4. Carefully pry out the output shaft seal and discard.

1. Install the new output shaft seal using the J 44809 .
2. Install the right rear wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement .
3. Inspect the rear drive module fluid level. Refer to Rear Axle Lubricant Level Inspection .
4. Install the right rear wheel and tire assembly. Refer to Tire and Wheel Removal and Installation .
5. Lower the vehicle.