Removal Procedure
Important: Allow the coolant surge tank sufficient cooling time before handling.
- Remove the coolant surge tank bolts.
Important: Do not disconnect the coolant hoses from the coolant surge tank.
- Disconnect the surge tank level sensor and set surge tank aside in engine compartment.
- Remove the front washer solvent container bolts.
- Disconnect the front washer solvent container hose from the front washer nozzle hose that runs along the upper motor compartment
rail.
- Angle the washer solvent container to the rear of the vehicle and pull out of the mounting hole.
- Disconnect the washer pump electrical connector.
Important: Contain any solvent the may spill while removing pump and hoses.
- Pull the washer solvent pump from the solvent container.
- Disconnect the front and rear washer solvent hoses from the washer pump.
Installation Procedure
Important: Do not reuse washer solvent as debris may clog the system.
- Connect the front and rear washer solvent hoses to the washer pump.
- Install the washer pump into the washer solvent container. Ensure the washer pump filter is installed, if removed.
- Connect the washer pump electrical connector.
- Insert the front and rear washer solvent container hoses into the grooves in the solvent container.
Important: Washer solvent container grommet must be installed between container and body structure to prevent squeaks and rattles.
- Install the washer solvent container into the motor compartment. Ensure that the washer solvent container's mounting peg, with grommet installed, is seated into the mounting hole in the body structure. A lubricant may be used to ease installation.
- Connect the front washer solvent container hose to front nozzle hose that runs along the upper motor compartment rail.
Notice: Refer to Fastener Notice in the Preface section.
- Install the washer solvent container screws.
Tighten
Tighten the screws to 2.5 N·m (22 lb in).
- Position coolant surge tank back into correct location.
- Install the coolant surge tank bolts.
Tighten
Tighten the bolts to 6 N·m (53 lb in).
- Fill the washer solvent container with washer solvent.