Tools Required

SA9164C Clamp Crimper

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.



3. Remove the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
4. Remove the jam nut.



5. Remove the spring from the boot, outer end.
6. Cut and remove the crimp clamp, inner end. Discard the clamp.
7. Unseat the boot from the steering gear and remove.



8. Clean the inner tie rod and boot contact area of grease and debris.

Important: The inner tie rod must be free of debris and moisture. The boot sealing areas must be clean and dry.

1. Apply approximately 3/4 of the supplied grease packet into the small end of the boot cavity. Apply the remainder of the grease on the shaft where the small end of the boot meets the shaft.




Important: Ensure the large end of the boot is firmly seated in the gear housing groove.

2. Install the boot with the large clamp loosely attached, not crimped.



3. Using the SA9164C , crimp the large clamp.

Important: Ensure the small end of the boot is firmly seated in the inner tie rod end groove.

4. Install the spring clamp to the small end of the boot.



5. Install the jam nut approximately 174 mm (6.85 in) from the boot clamp.



6. Install the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
7. Install the tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Check the front wheel alignment and align, as necessary. Refer to Wheel Alignment Measurement in Wheel Alignment.