Removal Procedure
- Remove the right side insulator/closeout panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel, Gages, and Console.
- Disconnect the electrical connector from the recirculation actuator.
- Remove the recirculation actuator screws from the HVAC module.
- Remove the recirculation actuator from the HVAC module.
Installation Procedure
- Align the recirculation actuator with the door shaft and rotate into position.
Notice: Refer to Fastener Notice in the Preface section.
- Install the recirculation actuator screws to the HVAC module.
Tighten
Tighten the screws to 1 N·m (9 lb in).
- Connect the electrical connector to the recirculation actuator.
- Cycle the ignition and verify proper operation.
- Install the right side insulator/closeout panel. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel, Gages, and Console.