Tools Required

J 44811 Accessory Belt Tensioner Unloader

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Install the J 44811 onto the tensioner.
3. Remove the accessory drive belt.

1. Route the belt around the alternator and the A/C compressor.



2. Install the J 44811 onto the tensioner and unload spring tension from the tensioner while positioning the belt.
3. Release the tensioner and remove the tool.

Notice: Refer to Fastener Notice in the Preface section.

4. Connect the negative battery cable

Tighten
Tighten the battery terminal bolt 17 N·m (23 lb ft).