Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



2. Loosen the front mount through bolt. Do not remove.



3. Loosen the rear mount through bolt. Do not remove.
4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.

Notice: Refer to Fastener Notice in the Preface section.

5. Tighten the rear motor mount through bolt.

Tighten
Tighten the bolt to 110 N·m (81 lb ft).




6. Tighten the front motor mount through bolt.

Tighten
Tighten the bolt to 110 N·m (81 lb ft).

7. Lower the vehicle.