Removal Procedure
Caution: Ensure that the vehicle is properly supported and squarely positioned.
To help avoid personal injury when a vehicle is on a hoist, provide additional support
for the vehicle on the opposite end from which the components are being removed.
Important: The evaporative emission (EVAP) canister is located under the center of the vehicle. It has 3 EVAP line connections:
• | The EVAP fresh air hose |
• | The EVAP purge connection |
• | The EVAP vent connection |
- Raise the vehicle on a hoist. Refer to
Lifting and Jacking the Vehicle
.
- Disconnect the EVAP canister fresh air line from the fuel tank fresh air line.
- Disconnect the EVAP canister purge line and vent line from the EVAP canister.
- Remove the EVAP canister-to-underbody fasteners.
- Disconnect the EVAP vent solenoid electrical connector.
- Remove the canister from the vehicle.
Installation Procedure
- Connect the EVAP vent solenoid electrical connector.
Notice: Refer to Fastener Notice in the Preface section.
- Install the EVAP canister-to-body underbody fasteners.
Tighten
Tighten the EVAP canister nuts to 8 N·m (71 lb in).
- Connect the EVAP canister purge and vent lines to the EVAP canister.
- Connect the EVAP canister fresh air line to the fuel tank fresh air line.
- Lower the vehicle from the hoist.