For 1990-2009 cars only
Removal Procedure
- Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle .
- Disconnect the EVAP canister fresh air line from the fuel tank fresh air line.
- Disconnect the EVAP canister purge line and vent line from the EVAP canister.
- Remove the EVAP canister-to-underbody fasteners.
- Disconnect the EVAP vent solenoid electrical connector.
- Remove the canister from the vehicle.
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
Important: The evaporative emission (EVAP) canister is located under the center of the vehicle. It has 3 EVAP line connections:
• The EVAP fresh air hose • The EVAP purge connection • The EVAP vent connection
Installation Procedure
- Connect the EVAP vent solenoid electrical connector.
- Install the EVAP canister-to-body underbody fasteners.
- Connect the EVAP canister purge and vent lines to the EVAP canister.
- Connect the EVAP canister fresh air line to the fuel tank fresh air line.
- Lower the vehicle from the hoist.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the EVAP canister nuts to 8 N·m (71 lb in).
