Tools Required

1. Pull each end of the hood rear seal away from the cowl panel flange near both strut towers.
2. Install three J-28467-13  (1) and two J 28467-5  strut tower adapters (2) to the top of the left and right strut tower.
3. Install a 127 cm (50 in) engine support fixture cross bar J-28467-B (3) transversely across the vehicle between both J 28467-5  strut tower adapters (2).
4. Insert safety pins J-28467-10 (4) through the J 28467-5  strut tower adapters (2) and the cross bar (3) to prevent movement.



5. Position two 58 cm (23 in) engine support fixture cross bars (1) longitudinally with two J 36462-A leg assembly (2).
6. Install two J 28467-1A  clamp (3) to secure the longitudinal mounted cross bar to the transverse mounted cross bar.



7. Assemble the lift hook wing nut J-28467-34, lift hook bracket J-28467-6A and lift hook J-28467-7A to the engine lift bracket on the engine.



8. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).
9. Position the J 28467-7A lift hook to the rear engine lift bracket.



10. Assemble the lift hook wing nut J-28467-34 and the lift hook bracket J-28467-6A to the lift hook J-28467-7A.



11. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).
12. Position the J 28467-7A bolt hook (1) to the front engine lift bracket.



13. Evenly tighten both wing nuts J-28467-34 (1) until the engine weight is supported by the engine support fixture and no longer carried by the engine mounts.