For 1990-2009 cars only
- Remove the bolt (711).
- Remove the manifold absolute pressure (MAP) sensor (712).
- Remove the O-ring (713) from the sensor, if required.
- Remove the throttle body coolant hoses.
- Remove the nuts (519) and bolts (555).
- Remove the throttle body (518) and gasket (517).
- Remove the studs (516), if required.
Important: The powertrain control module (PCM) must perform the idle learn procedure to determine the minimum throttle position and to establish idle speed when any of the following components are replaced:
• Throttle body • Timing belt • Timing belt drive sprocket
Refer to
Idle Learn
.
• Crankshaft and bearings
