Tools Required
EN 46331
Timing Belt Tensioner
Pulley Retaining Bolt
Important: The powertrain control module (PCM)
must perform the idle learn procedure to determine the minimum throttle position and
to establish idle speed when any of the following components are replaced:
• | Timing belt drive sprocket |
• | Crankshaft and bearings |
Refer to
Idle Learn
.
- Use the
EN 46331
to retain
the tensioner pulley. Tighten until snug.
- Loosen the idler pulley bolt (238)
about 5 or 6 turns.
- Remove the belt (235).
- Remove the
EN 46331
.