Removal Procedure
- Remove the generator battery control module cover.
- Disconnect the engine wiring harness electrical connector (1) from the intake camshaft position (CMP) sensor.
- Remove the CMP sensor bolt.
- Remove the CMP sensor.
Installation Procedure
Important: Inspect the CMP sensor for damage, replace as necessary.
- Lubricate the CMP sensor O-ring seal with clean engine oil.
Notice: Refer to Fastener Notice in the Preface section.
- Install the CMP sensor.
- Install the CMP sensor bolt.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Connect the engine wiring harness electrical connector (1) to the intake CMP sensor.
- Install the generator battery control module.