Removal Procedure
- Disconnect the instrument panel wiring harness electrical connector from the accelerator pedal position (APP) sensor.
Important: Due to clearance issues, the upper bolt cannot be removed from the sensor. Loosen the bolt and leave the bolt in the sensor until the sensor is removed.
- Remove the APP sensor bolt.
- Remove the APP sensor.
Installation Procedure
- Install the APP sensor.
Notice: Refer to Fastener Notice in the Preface section.
- Install the APP sensor bolt.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
- Connect the instrument panel wiring harness electrical connector to the APP sensor.