GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 977314  Size: SH
  1. Remove the instrument panel (I/P) center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
  2. Remove the radio screws.

  3. Object Number: 318001  Size: SH
  4. Disconnect the radio electrical connectors and the antenna. Slightly push the antenna lead toward the radio to relieve tension on the internal fingers. Then pull back on the spring-loaded locking ring and remove the connector from the radio.
  5. Remove the radio.

Installation Procedure

  1. Position the radio in the vehicle.

  2. Object Number: 318001  Size: SH
  3. Connect the electrical connectors and the antenna.
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 977314  Size: SH
  5. Install the radio screws.
  6. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  7. Install the I/P center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
  8. Set up the radio. Refer to Control Module References for programming and setup information.