- Install a scan tool.
- Diagnose and repair any DTCs before proceeding with this procedure. Refer to
Diagnostic Trouble Code (DTC) List - Vehicle
for the applicable DTC that set.
- Ensure that all electrical loads and accessories are OFF.
- Turn OFF the air conditioning.
- Ensure that the vehicle is in PARK or NEUTRAL.
- Turn ON the ignition.
- Clear the DTC information with the scan tool.
- Wait 5 seconds and start the engine.
- Operate the engine with no load at 3,000 RPM until the ECT reaches 90°C (194°F).
Important: If the engine cooling fan turns ON during the idle portion of this procedure, do not include the fan run time in the total idle time.
- Let the engine idle with the THROTTLE CLOSED and the engine cooling fan OFF, for a total of 5 minutes.
- The PCM has a new learned idle position.
- The idle learn procedure is required when the following service procedures have been performed:
• | The throttle body assembly is replaced |
• | The throttle valve is cleaned--Deposits can build up in the throttle body requiring periodic cleaning of the throttle valve and throttle bore area. Refer to
Throttle Body Inspection and Cleaning
. |
• | The Clear DTCs function has been performed |
• | The PCM has been programmed. |
Idle Speed Inspection
- Install a scan tool.
- Ensure that all electrical loads and accessories are OFF.
- Turn OFF the air conditioning.
- Ensure that the vehicle is in PARK or NEUTRAL.
- Start and run the engine until the ECT is at least 80°C (176°F).
- Ensure that the scan tool data parameter Engine at Operating Temperature says YES.
- Observe that the engine speed is 730 RPM +/-50 RPM with the scan tool.
- Idle the engine for 1 minute with the AC ON and the blower motor operating on HIGH.
- Observe that the engine speed is 730 RPM +/-50 RPM with the scan tool.
- Compare the engine speed at idle with the scan tool to the following specifications:
• | All engine accessories OFF--730 RPM +/-50 RPM |
• | Turn the AC ON and the heater fan on HIGH--730 RPM +/-50 RPM |
- If the scan tool indicated that the engine idle was within the specified values, the idle speed is normal.
- If the scan tool indicated that the engine idle was more than or less than specified values, refer to
Rough, Unstable, or Incorrect Idle and Stalling
.