Important:
• | It is not necessary to check the fluid level unless the fluid has been changed or a leak is suspected. |
• | Inspect the fluid level only when the engine is off. Ensure the vehicle is level. The transaxle must be cold. |
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle .
- Remove the fluid level check plug (2).
- Verify that the fluid is level with the opening.
- If the transaxle is not properly filled, remove the fluid fill cap (1) and carefully add manual transmission and transfer case fluid G/M P/N 88861800 (Canadian P/N 88861801) until it begins to flow out of the fill/check
plug hole.
Notice: Refer to Fastener Notice in the Preface section.
- Install the fluid level check plug (2).
Tighten
Tighten the fluid level check plug to 38 N·m (28 lb ft).
- Lower the vehicle.