Battery And SES Light With DTC U0120 After SGCM Jumper Harness Installation - keywords 07-06-03-04 07195 BAS circuit communication crank hybrid lamp loss MIL no SGCM start starter wiring
| Subject: | Battery and SES Light with DTC U0120 After SGCM Jumper Harness Installation |
| Models: | 2007 Saturn VUE Hybrid |
| only with 2.4L Engine (VIN Z - RPO LAT) |
| and SGCM Jumper Harness from 07195 |
| or 07-06-03-004 |
This PI was superseded to update search criteria and reference 07195. Please discard PIP4212.
The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.
Condition/Concern:
Shortly after having the SGCM Jumper Harness from 07195 or 07-06-03-004 installed for a P0A4B DTC, the vehicle may return with a U0120 DTC, SES Light, and Battery Light.
Recommendation/Instructions:
If this concern occurs, inspect the SGCM jumper harness to ensure that:
| • | none of the C2 SGCM connector terminals are backed out from when it was originally plugged in. To do this, unplug the lower SGCM connector (C2), remove the clear connector face cover, and inspect all of the terminals to ensure that they are seated properly. |
| • | terminals 1, 3, 8, and 21 were transferred from the original C2 SGCM connector to the new C2 SGCM jumper harness connector as outlined in step 2.7 of 07-06-03-004. There have been instances where the wrong terminals were transferred. |
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.
