• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The battery energy control module (BECM) monitors to detect a fault with the contactor.
The Link Voltage is the voltage on the 36 volt cable between the SGCM and the BECM, Pack voltage is the sum of all module voltages. Refer to Hybrid Energy Storage Schematics for detailed information.
Ignition to OFF, transition from contactor closed to contactor open.
Absolute Value (Pack Voltage - Link Voltage) is less than 1 volt.
The hybrid system is disabled.
• | State = Run or Service or Powerdown. |
• | Pack current is less than -0.1 amps. |
• | Contactor state = Open. |
• | Contactor status = Open Service Disconnect. |
• | Current sensor DTCs = Passed. |
• | Pack voltage reading = Valid. |
• | Pack voltage DTCs = Passed. |
Hybrid Energy Storage Schematics
Generator Battery Carrier Description and Operation
Control Module References for scan tool information
⇒ | If the DTC resets, replace the BECM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BECM replacement, setup, and programming.