For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0558: Calibration Data Not ProgrammedCircuit/System Description
The rear differential clutch control module (CCM) is required to have the correct calibration data (matching ID) stored in the memory from the AWD coupling control, and is part of the programming used to perform all wheel drive functions.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The calibration data (matching ID) of the CCM is not programmed or incorrectly programmed.
Action Taken When the DTC Sets
All wheel drive indicator illuminates.
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The DTC is not detected in 40 consecutive drive cycles. |
Reference Information
Schematic Reference
Connector End View Reference
DEscription and Operation
All-Wheel Drive Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify that DTC C0558 is not set.
| ⇒ | If the DTC is set, program the CCM. If the DTC resets, replace the CCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for CCM replacement, setup, and programming
