DTC C0292. Suzuki XL-7 AWD 2007

For 1990-2009 cars only

Makes 🢒 Suzuki 🢒 2007 🢒 XL-7 AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 DTC C0292

Diagnostic Fault Information

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0292 : VSES Combination Sensor Circuits

The electronic brake control module (EBCM) supplies a reference voltage of 5 volts to the yaw rate sensor lateral accelerometer and the steering wheel position sensor. The sensor supply voltage is monitored via an internal feedback circuit to the EBCM microprocessor.

Conditions for Running the DTC

•	The ignition is ON.

•	Ignition voltage is greater than 9.5 volts.

Conditions for Setting the DTC

The yaw/lateral sensor is setting an internal electronic failure.

Action Taken When the DTC Sets

•	Vehicle stability enhancement system (VSES) is disabled

•	The VSES indicator turns ON.

•	The driver information center (DIC) displays the Service ESC message.

Conditions for Clearing the DTC

•	The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool.

•	The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

If the yaw and lateral accelerometer sensor is disconnected, DTCs will set and the EBCM will not provide 5-volt reference.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Antilock Brake System Connector End Views

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Scan Tool Data List for EBCM

Circuit/System Testing

Ignition OFF, disconnect the yaw rate sensor/lateral accelerometer connector.
Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit and ground.

⇒	If greater than 1 ohm, test the low reference circuit and the EBCM ground circuit for an open/high resistance. If the circuits test normal, replace the EBCM.

Test the lateral accelerometer signal circuit, the 5-volt reference circuit, and the low reference circuit for an open/high resistance or a short to voltage or ground.

⇒	If all circuits test normal, replace the yaw rate sensor/lateral accelerometer.

⇒	If the DTC sets again after replacing the yaw rate sensor/lateral accelerometer, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for EBCM replacement, setup, and programming