DTC P0626. Suzuki XL-7 AWD 2007

For 1990-2009 cars only

Makes 🢒 Suzuki 🢒 2007 🢒 XL-7 AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 DTC P0626

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0626: Generator F-Terminal Circuit High Voltage

The engine control module (ECM) uses the generator field duty cycle signal circuit to monitor the duty cycle of the generator and fault indication. The generator field duty cycle signal circuit connects to the high side of the field winding in the generator. A pulse width modulated (PWM) high side driver in the voltage regulator turns the field winding ON and OFF. The ECM uses the PWM signal input to determine the generator load on the engine. This allows the ECM to adjust the idle speed to compensate for high electrical loads.

The ECM monitors the state of the generator field duty cycle signal circuit. When the engine is running, the ECM should detect a duty cycle that varies up to 100 percent. The ECM monitors the PWM signal using a Ignition ON test and a RUN test. During the tests, if the ECM detects an out of range PWM signal, a DTC will set.

Conditions for Running the DTC

•	The engine is not running.

•	The ignition is in the ON position.

Conditions for Setting the DTC

The ECM detects a pulse width modulated (PWM) signal greater than 65 percent for at least 15 seconds.

Action Taken When the DTC Sets

•	The ECM will command the charge indicator and or warning message to be illuminated on the instrument panel cluster (IPC) and the driver information center (DIC), if equipped.

•	The ECM will not illuminate the malfunction indicator lamp (MIL).

•	The ECM will store conditions, which were present when the DTC set as Failure Records data only.

Conditions for Clearing the DTC

•	The ECM will command the message OFF after one trip in which the diagnostic test has been run and passed.

•	The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.

Reference Information

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

•	Scan Tool Data List

•	Scan Tool Data Definitions

Circuit/System Verification

Ignition ON, engine running, observe the scan tool ECM GEN-F Terminal Signal parameter. The GEN-F Terminal Signal parameter should read between 5-95 percent.

Circuit/System Testing

Ignition OFF, disconnect the harness connector at the generator.
Ignition ON, engine OFF, observe the scan tool ECM GEN-F Terminal Signal parameter. It should display less than 10 percent.

⇒	If the GEN-F Terminal Signal parameter was not affected by the disconnected generator harness, test the GEN-F Terminal Signal circuit for a short to voltage. If the circuit tests normal , replace the ECM.

⇒	If the circuit tested normal and the ECM parameter changed from above 65 percent to less than 10 percent, replace the generator.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming

Generator Replacement