GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Suzuki 🢒 2009 🢒 XL-7 AWD 🢒 Engine 🢒 Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Power Steering Pump Replacement

Removal Procedure

    Note: Do not remove the drive belt from the vehicle entirely. Only slip it off the power steering pump and set it aside in the engine compartment.

  1. Remove the drive belt. Refer to Drive Belt Replacement.
  2. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
  3. Remove the right side engine splash shield. Refer to Engine Splash Shield Replacement - Right Side.
  4. Place drain pans under the vehicle as needed.

    5. Object Number: 1818200 Size: SH
  5. Compress the power steering reservoir outlet hose clamp (1) and disconnect the power steering reservoir outlet hose (2) from the power steering pump.

    6. Object Number: 1818210 Size: SH
  6. Disconnect the power steering gear inlet hose (1) from the power steering pump.

    7. Object Number: 1818216 Size: SH
  7. Remove the power steering pump bolts (1).
  8. Remove the power steering pump through the right wheel house area.
  9. Transfer the power steering pulley if needed. Refer to Power Steering Pump Pulley Replacement.

Installation Procedure
  1. Position the power steering pump to the vehicle through the right wheel house area.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1818216 Size: SH
  2. Install the power steering pump bolts (1).

    3. Tighten
    Tighten to 50 N·m (37 lb ft).


    Object Number: 1818210 Size: SH
  3. Connect the power steering gear inlet hose (1) to the power steering pump.

    4. Tighten
    Tighten to 25 N·m (18 lb ft).


    Object Number: 1818200 Size: SH
  4. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the power steering pump.
  5. Install the right side engine splash shield. Refer to Engine Splash Shield Replacement - Right Side.
  6. Clean any excess power steering fluid from the vehicle and remove the drain pans.
  7. Install the drive belt. Refer to Drive Belt Replacement.
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding.