For 1990-2009 cars only
Removal Procedure
- Disconnect the accelerator pedal assembly electrical connector.
- Remove the retaining clip and washer from the brake pedal.
- Release the brake booster pushrod from the brake pedal.
- Disconnect the brake pedal position sensor electrical connector.
- Remove the brake pedal bracket-to-steering column bracket bolt.
- Remove the brake booster mounting nuts.
- Position the brake booster forward to clear the studs from the front of the dash.
- Loosen, but do not remove, the steering column bracket to cowl nut.
- While simultaneously disengaging the brake pedal bracket pilot bushings from the foam insulation panel, pull the brake pedal assembly back and toward the center of the vehicle.
- Remove the brake pedal assembly from the vehicle.
- Remove the accelerator pedal assembly from the brake pedal bracket. Refer to Accelerator Pedal Position Sensor Replacement.
Installation Procedure
- Install the accelerator pedal assembly to the brake pedal bracket. Refer to Accelerator Pedal Position Sensor Replacement.
- Install the brake pedal assembly into the vehicle, while guiding the brake pedal bracket pilot bushings into the foam insulator panel.
- Position the booster studs through dash panel.
- Install the brake pedal bracket-to-steering column bracket bolt and tighten the bolt to 25 N·m (18 lb ft).
- Loosely install the brake booster mounting nuts.
- Apply a thin coating of lithium grease to the pushrod pin on the brake pedal.
- Connect the brake booster pushrod to the brake pedal.
- Install the washer and retaining clip to the brake pedal.
- Tighten the vacuum brake booster mounting nuts to 25 N·m (18 lb ft).
- Install the steering column bracket to the cowl nut and tighten to 25 N·m (18 lb ft).
- Connect the brake pedal position sensor electrical connector.
- Connect the accelerator pedal assembly electrical connector.
Caution: Refer to Fastener Caution in the Preface section.
