GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Suzuki 🢒 2009 🢒 XL-7 AWD 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Exhaust Manifold Heat Shield Replacement - Right Side

Removal Procedure

    Warning: Refer to Exhaust Service Warning in the Preface section.

    Warning: Refer to Protective Goggles and Glove Warning in the Preface section.


    Object Number: 1836230 Size: SH
  1. Remove the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (2).
  3. Remove the HO2S electrical connector retainer from the camshaft cover.

    4. Object Number: 1836985 Size: SH
  4. Remove the exhaust manifold heat shield bolts.
  5. Remove the exhaust manifold heat shield, sliding the shield up over the HO2S pigtail.

Installation Procedure

    Object Number: 1562768 Size: SH
  1. Install the exhaust manifold heat shield, sliding the shield down over the HO2S pigtail.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the exhaust manifold heat shield bolts and tighten to 10 N·m (89 lb in).

    3. Object Number: 1836230 Size: SH
  3. Connect the engine wiring harness electrical connector (3) to the HO2S electrical connector (2).
  4. Install the HO2S electrical connector retainer to the camshaft cover.
  5. Install the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement.