Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B0000 5A: Vehicle Speed Information Circuit Plausibility FailureDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Vehicle Speed Signal | B0000 5A | B0000 5A | B0000 5A | B0000 5A |
Circuit/System Description
The radio receives a vehicle speed signal from the electronic brake control module (EBCM) in order to correlate actual vehicle speed to the movement of the vehicle calculated by the navigation system and reported serial data.
Conditions for Running the DTC
| • | Radio ON. |
| • | Battery voltage must be between 9-16 volts. |
Conditions for Setting the DTC
The DTC will set for one or more of the following conditions.
| • | Vehicle speed from serial data is more than 5 km/h (3 mph) and vehicle speed pulse from the EBCM is 0 km/h (0 mph). |
| • | Vehicle speed calculated from the navigation processing software is more than 36 km/h (22 mph) and vehicle speed pulse from the EBCM is 0 km/h (0 mph) for 10 seconds continuously. |
Action Taken When the DTC Sets
| • | Turn by turn route navigation may be inoperative. |
| • | Vehicle indicated location may be inaccurate. |
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC clears after 100 malfunction-free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Entertainment/Communication Connector End Views
Description and Operation
Navigation System Description and Operation
Electrical Information Reference
Circuit/System Testing
Important: Diagnose any antilock brake system (ABS) related DTCs before performing this diagnostic.
- Ignition OFF, disconnect the radio harness connector X4. Connect a DMM to the vehicle speed signal (VSS) circuit terminal 5 and ground.
- Ignition ON, operate the vehicle drive wheels at 5 mph. Verify 3-7 Hertz on the VSS circuit.
- If the circuit tests normal, replace the radio.
| ⇒ | If not within the specified range, test the VSS circuit for an open, high resistance, short to ground or short to voltage. If the circuit tests normal replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for radio or EBCM replacement, setup, and programming
