• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The Rear Differential Clutch Control module (RDCCM) receives messages from other modules over GMLAN which are needed to perform all wheel drive functions
• | The ignition switch is in the ON position. |
• | Ignition voltage is greater than 9 volts. |
The RDCCM receives an invalid message from PCM, EBCM, modules over GMLAN which causes the RDCCM to deactivate.
One or more of the following actions may occur:
• | All Wheel Drive Off (AWD Disabled). |
• | Service All Wheel Drive (Service AWD). |
• | The condition for the DTC is no longer present. |
• | The DTC is not detected in 40 consecutive drive cycles. |
DTC C0561 is an indicator that the RDCCM receives an invalid message from the ECM, or EBCM , and does not necessarily indicate a fault is present with the RDCCM. This DTC should not be used as a fault indicator, but rather as a symptom to assist in the diagnosis of these other systems.
Transfer Case Control Connector End Views
All-Wheel Drive Description and Operation
Scan Tool Data List for Scan Tool Information
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for RDCCM replacement, setup, and programming