Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Diagnostic Fault Information
Circuit | Short to Ground | High Resistance | Open | Short to Voltage | Signal Performance |
|---|---|---|---|---|---|
B+ Voltage Reference | 1 | B3794 08, B3794 6 | 1 | 1 | B3794 08, B3794 61 |
Cruise Control Switch Signal | 1 | B3794 08, B3794 6 | 1 | B3794 08 | B3794 08, B3794 61 |
Cruise Control Indicator Low Reference | -- | 2 | 2 | 2 | -- |
1. Cruise Control Malfunction 2. Cruise Control Switch Indicator Malfunction | |||||
Circuit/System Description
The cruise control switch contains an LED that illuminates to indicate the cruise control system has been switched ON. Voltage is applied through the ON/OFF switch to the LED when the switch is pressed. The body control module (BCM) provides the ground path for the LED through a dedicated LED control circuit. Pressing the switch again opens the switch and the lamp turns OFF.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Cruise Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Ignition ON, observe the cruise control indicator while applying the cruise on/off switch. The indicator should turn on and off accordingly with the applied switch.
Circuit/System Testing
Important: Refer to DTC B3794 before performing this diagnostic, if this code is set as current or history.
- Ignition OFF, disconnect the harness connector at the steering wheel control switch-left.
- Ignition ON, verify that a test lamp illuminates between the low reference circuit terminal 9 and B+.
- If all circuits test normal, test or replace the steering wheel controls switch-left
| ⇒ | If the test lamp does not illuminate, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
