GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1836024  Size: SH
  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.
  2. Disconnect the engine wiring harness electrical connector (2) from the bank 2 intake camshaft position (CMP) actuator solenoid valve.

  3. Object Number: 1285234  Size: SH
  4. Remove the CMP actuator solenoid valve bolt.
  5. Remove the CMP actuator solenoid valve.
  6. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.

Installation Procedure


    Object Number: 1285234  Size: SH
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
  2. Install the CMP actuator solenoid valve.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the CMP actuator solenoid valve bolt.
  5. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1836024  Size: SH
  6. Connect the engine wiring harness electrical connector (2) to the bank 2 intake CMP actuator solenoid valve.
  7. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.