GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Suzuki 🢒 2008 🢒 XL-7 FWD 🢒 Seats 🢒 Seat Hardware, Trim, and Upholstery 🢒 Rear Seat Replacement

Removal Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1865004 Size: SH
  1. Insert a M10 bolt (1) with 45 mm (1.77 in) of thread into the weld nut located on the upper pivot bracket of the outboard pivot assembly.

    2. Tighten
    Tighten the bolts to 15 N·m (11 lb ft).


    Object Number: 1865005 Size: SH
  2. Remove the stud caps and the 6 attachment nuts (1) from the front and side risers of the seat.

    3. Object Number: 1865006 Size: SH
  3. Pull the latch release strap (1) at the rear of the seat to release the floor latches (2).
  4. Remove the seat from the vehicle.

Installation Procedure

    Object Number: 1865006 Size: SH
  1. Install the rear seat to the vehicle, locating the seat over the studs on the floor.
  2. Secure the rear of the seat by pushing down on the back of the seat ensuring that the seat latch (2) is securely latched.

    3. Object Number: 1865005 Size: SH
  3. Install the 6 attachments nuts (1) to the front and side risers of the seat.

    4. Tighten
    Tighten the bolts to 40 N·m (30 lb ft).

  4. Remove the bolt (1) after that seat is securely in place.

    5. Object Number: 1865004 Size: SH
  5. Return the rear seat to its original position.