For 1990-2009 cars only
Special Tools
| • | EN-46106 Engine Flywheel Holding Tool |
| • | J-45059 Angle Meter |
For equivalent regional tools, refer to Special Tools
- Place the engine flywheel in position on the crankshaft.
- Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
- Install the EN-46106 tool .
- Install the remaining NEW engine flywheel bolts and tighten to 30 N·m (22 lb ft) and an additional 45 degrees using the J-45059 meter .
- Remove the EN-46106 tool .
Caution: Refer to Fastener Caution in the Preface section.
