For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Disconnect the engine wiring harness electrical connector (2) from the bank 2 knock sensor.
- Loosen the knock sensor bolt and remove the knock sensor.
Installation Procedure
- Position the knock sensor and tighten the knock sensor bolt tightening the bolt to 23 N·m (17 lb ft).
- Connect the engine wiring harness electrical connector (2) to the bank 2 knock sensor.
- Lower the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
