GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Suzuki 🢒 2009 🢒 XL-7 FWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust

Removal Procedure

    Object Number: 1836024 Size: SH
  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.
  2. Disconnect the engine wiring harness electrical connector (7) from the bank 2 exhaust camshaft position (CMP) actuator solenoid valve.

    3. Object Number: 1285231 Size: SH
  3. Remove the CMP actuator solenoid valve bolt.
  4. Remove the CMP actuator solenoid valve.
  5. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.

Installation Procedure

    Object Number: 1285231 Size: SH
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
  2. Install the CMP actuator solenoid valve.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the CMP actuator solenoid valve bolt tightening the bolt to 10 N·m (89 lb in).

    4. Object Number: 1836024 Size: SH
  4. Connect the engine wiring harness electrical connector (7) to the bank 2 exhaust CMP actuator solenoid valve.
  5. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.