For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Disconnect the EVAP canister fresh air hose/pipe from the fuel tank fresh air hose/pipe (2). Refer to Plastic Collar Quick Connect Fitting Service.
- Disconnect the EVAP canister vent hose/pipe from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
- Disconnect the EVAP canister purge hose/pipe (1) from the EVAP canister.
- Remove the EVAP canister-to-underbody nuts (3).
- Lower the EVAP canister.
- Disconnect the EVAP vent solenoid electrical connector (1).
- Remove the EVAP canister (4) from the vehicle.
Note: The EVAP emissions canister is located under the center of the vehicle. It has 3 EVAP line connections:
• The EVAP fresh air • The EVAP vent • The EVAP purge
Caution: Clean all fuel pipe connections and surrounding areas before disconnecting the fuel pipes to avoid contamination of the fuel system.
Installation Procedure
- Connect the EVAP vent solenoid electrical connector (1).
- Install the EVAP canister (4) to the underbody of the vehicle.
- Install the EVAP canister-to-underbody nuts (3) tightening the nuts to 9 N·m (80 lb in).
- Connect the EVAP canister purge hose/pipe (1) to the EVAP canister.
- Connect the EVAP canister vent hose/pipe (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service.
- Connect the EVAP canister fresh air hose/pipe to the fuel tank fresh air hose/pipe (2). Refer to Plastic Collar Quick Connect Fitting Service.
- Lower the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
