Preliminary Procedure

Remove the multifunction turn signal switch housing. Refer to Multifunction Turn Signal Switch Housing Replacement.

1

Ignition Lock Cylinder Case Bolt

Caution: Refer to Fastener Caution in the Preface section.

Procedure

1. Use a small chisel and hammer to back out the ignition lock cylinder case bolt counterclockwise and remove it.
2. When installing a new ignition lock cylinder case bolt continue to tighten it until the head shears off.

2

Ignition Lock Cylinder Case Strap

3

Ignition Lock Cylinder Case

Procedure

Disconnect any electrical connectors as needed.

Tip
The ignition lock cylinder must be turned to the run position in order to remove and/or install the ignition lock cylinder case.