Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Wiper/Washer System Check? | -- | Go to Step 2 | |
2 |
Is the resistance within the specified range? | 1.224-0.024 Mohms | Go to Step 3 | Go to Step 4 |
3 | Measure the resistance through the connector from terminal C or terminal D (Buick pulse) to terminal F or terminal A (Buick pulse) using a J 39200. Is the resistance less than the specified value? | 3 ohms | Go to Step 5 | Go to Step 4 |
4 | Replace the wiper/washer switch. Refer to Windshield Wiper and Washer Switch Replacement - On Vehicle . Did you complete the repair? | -- | -- | |
5 | Test CKT 94 and CKT 91 for an open or poor connection. Does an open or poor connection exist? | -- | Go to Step 6 | Go to Step 7 |
6 | Repair the open or poor connection in CKT 94 and CKT 91. Did you complete the repair? | -- | -- | |
7 | Remove the wiper motor cover. Refer to Wiper Motor Cover Replacement . Are the park switch pulse terminals touching the pads on the circuit board? | -- | Go to Step 8 | Go to Step 9 |
8 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Did you complete the repair? | -- | -- | |
9 | Replace the park switch spring contacts. Did you complete the repair? | -- | -- |
