Removal Procedure
- Raise the hood.
- Remove the front fascia. Refer to
Front Bumper Fascia Replacement
in
Bumpers.
- Remove the front impact bar. Refer to
Front Bumper Impact Bar Replacement
in
Bumpers.
- Remove the solvent container filler neck.
- Remove the washer pump hose from the washer pump.
- Disconnect the washer pump wiring electrical connector.
- Disconnect the level sensor wiring electrical connector.
- Remove the solvent container.
- If replacing the solvent container transfer the following components:
• | Remove the washer pump. |
• | Remove the solvent container level Sensor. |
Installation Procedure
- If the solvent container
was replaced, install the following components:
• | Install the washer pump. |
• | Install the solvent container level sensor. |
- Install the solvent container.
- Connect the level sensor wiring electrical connector.
- Connect the washer pump wiring electrical connector.
- Install the washer pump hose to the washer pump.
- Install the solvent container filler neck.
- Install the front impact bar. Refer to
Front Bumper Impact Bar Replacement
in Bumpers.
- Install the front fascia. Refer to
Front Bumper Fascia Replacement
in Bumpers.
- Close the hood.