Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: The TRUNK AJAR or TONNEAU AJAR messages are always displayed, or do not display. | ||||
1 | Has the Body Rear End Diagnostic System Check been performed? | -- | ||
2 |
Is the TRUNK AJAR or TONNEAU AJAR message displayed on the driver information center? | -- | ||
3 | Install a scan tool and display the input data 2 list. Does the scan tool indicate the Hatch/Trunk Ajar Switch or Folding Top Ajar Switch is open? | -- | ||
4 |
Is the TRUNK AJAR or TONNEAU AJAR message displayed on the driver information center? | -- | ||
5 | Test and repair the inoperative ajar switch signal circuit for a short to ground. Did you find and correct the condition? | -- | ||
6 |
Does the scan tool indicate the Hatch/Trunk Ajar Switch or Folding Top Ajar Switch is open? | -- | ||
7 |
Is the TRUNK AJAR or TONNEAU AJAR message displayed on the driver information center? | -- | ||
8 | Replace the inoperative latch assembly. Refer to one of the following procedures: Is the repair complete? | -- | -- | |
9 |
Is the TRUNK AJAR or TONNEAU AJAR message displayed on the driver information center? | -- | ||
10 | Repair the open or high resistance in the inoperative ajar switch ground circuit 150. Is the repair complete? | -- | -- | |
11 | Test and repair the inoperative ajar switch signal circuit for an open or high resistance. Did you find and correct the condition? | -- | ||
12 | Replace the BCM. Refer to Body Control Module Replacement and Body Control Module (BCM) Programming/RPO Configuration . Is the repair complete? | -- | -- | |
13 | Replace the instrument cluster. Refer to Instrument Cluster Replacement . Is the repair complete? | -- | -- | |
14 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | |
